How to Replace the Lens on a BMW 325

Removing and Replacing
1. Pull the lever located near the foot pedals on the drivers side of your BMW 325 to unlatch your hood. Face the hood of your vehicle and pull the hood-release lever located in the grille of your car to fully open the hood.
2. Shine your flashlight to the lower right or left corner inside your hood to find the interior part of your corner turn lens. Locate an oval-shaped hole behind the corner turn lens.
3. Push down and outward on the plastic clip within the oval hole with your flathead screwdriver to release the corner turn lens. Continue to keep your screwdriver in place within the oval hole while pulling the corner turn lens out with your free hand. Set the corner turn lens aside for re-installation. Removing your corner turn lens makes the headlight lens accessible for removal.
4. Lift up on the three tabs located on the top of the rubber trim that surrounds your headlight lens with your fingers. Remove the trim to loosen your headlight lens. Set the trim aside for re-installation.
5. Move your fingers around the top of your headlight lens and pull up on the three tabs that secure the headlight lens in place. Repeat this procedure on the bottom of the lens. Pull one tab out from each side of the lens. Pull the lens towards you once all tabs are released.
6. Align your new headlight lens in place. Push it with slight force to snap it into place. Push the rubber trim back into place snapping the connected tabs down. Push the corner turn lens into its original position until it clips back in.
7. Repeat Steps 1 to 7 to replace the headlight on the opposite side of your BMW 325.