Care must be taken when installing this accessory to ensure the damage does not occur on the vehicle. This accessory installation should follow accepted guidelines to ensure a quality installation. These instructions can be found in the "Accessory installation Practices" document. This document covers such as: • vehicle security (use of covers and blankets, cleaning, chemical products, etc.). • Safety (safety glasses, rechecking the torque procedure, etc.). • Vehicle/base maintenance (delete the Panel, part of the storage, etc.). • Electronic Component/base maintenance (battery disconnection, removal of the connector, etc.). View Toyota dealer, a copy of the file. 1. protection of the vehicle. (a) from the drivers seat is placed in the middle. (b) to set the emergency brake. (c) remove the negative battery cable. (Figure 1-1) (1) to protect the fender before you begin. Caution: do not touch the positive terminal in any software when you disconnect the cable. (d) use of protective blankets to cover the Interior of the vehicle and the front seats, center console and gearshift knob on the side of the face. e wait 90 seconds before proceeding to decode the vehicle. 2. the dismantling of the vehicle. Note: insert the components in the protected surface of all recovered. Note: when you disconnect a cable, pull on the wires to the connectors; Drag the connector only. (b) remove the air conditioning control (L, R). (Figure 2-1) (1) to apply the protective tape. (2) with the help of a panel remover to detach the clips and remove the 4 air conditioning control.
Download here
